ADTRAN TRACER User Manual page 2

P
AGE II
RADIO FREQUENCY INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for
an intentional radiator, pursuant to Part 15, Subpart C of the FCC Rules.
This equipment generates, uses, and can radiate radio frequency energy.
If not installed and used in accordance with the instructions, it may
cause interference to radio communications.
The limits are designed to provide reasonable protection against such
interference in a residential situation. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause interference to radio or television reception, which
can be determined by turning the equipment on and off, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna of the affected radio or
television.
• Increase the separation between the equipment and the affected
receiver.
• Connect the equipment and the affected receiver to power outlets
on separate circuits.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by ADTRAN
could void the user's authority to operate the equipment.
SHIELDED CABLES
A shielded-type power cord is required in order to meet FCC emission
limits and also to prevent interference with nearby radio and television
reception when using the AC voltage adapter. It is essential that only
the Adtran-provided power cord be used.
FCC OUTPUT POWER RESTRICTIONS
The FCC does not require licensing to implement this device. However,
the FCC has established restrictions regarding maximum output power
and the adjustments required when employing directional gain antennae.
(Refer to "Setting the Transmitter Power" in Section 2 of this manual).
These restrictions are detailed in FCC Part 15.247 (b)(1), (b)(3)(i), and
(3)(iii). It is the responsibility of the individuals designing and
implementing the radio system to assure compliance with these and any
other pertinent FCC Rules and Regulations. This device must be
professionally installed.
W A R N I N G
61280.003L1-1B
6/18/98