Pair The Cc Transmitter To Your Idive - Ratio CC Transmitter User Manual

Pair the CC Transmitter to your iDive

After powering up the CC transmitter, go on TRANSMIT menu on your iDive (by pressing the bottom-left button on the
watch screen and swipping the menu entries).
TX ID: OFF
TANK RES: 30
RESET
EXIT
C
iDive
Next
entry
0.0
OC
0
:00
MIX RBT BAR
21 ---
---
iDive
Place the iDive about 20-30cm from the CC Transmitter (Attention: If you place the
CC Transmitter to close to the iDive the pairing procedure may not work properly).
B
SRC
Press B to start the search of the CC Transmitter (SRC).
D
As soon as the Pair is done, the TX ID of the CC Transmitter will be displayed.
-
(Each CC Trasnmitter has 31 TD ID channels, the TX ID is randomly assigned in order to avoid interferences with
other CC Transmitters. To change the TX ID of your CC Transmitter see the dedicated chapter on this manual).
In order to check the correct pair of the CC Trasnsmitter activate the dive mode in
your iDive. Within about 30 sec. the tank pressure will be displayed in the bottom-
right corner of the display (BAR)
(RBT will be displayed only during the dive. See dedicated chapter on this manual)
After the first pair your iDive and your CC Transmitter will connect automatically
(the iDive have to be in dive mode).
Attention: Using the CC Transmitter will reduce the autonomy of your iDive at about
20 diving hours. Set the TX ID on "OFF" in you are not using a CC Transmitter.
20-30cm
14