Poulan Pro 192362 Owner's Manual page 9

2. Pivot seat upward and remove from
the cardboard packing. Remove the
cardboard packing and discard.
3. Place seat on seat pan so head of
shoulder bolt is positioned over large
slotted hole in pan.
4. Push down on seat to engage shoulder
bolt in slot and pull seat towards rear of
tractor.
5. Pivot seat and pan forward and as-
sem ble adjustment knob and fl at
washer loosely. Do not tighten.
6. Lower seat into operating position and
sit in seat.
7. Slide seat until a comfortable position
is reached which allows you to press
clutch/brake pedal all the way down.
8. Get off seat without moving its ad-
just ed position.
9. Raise seat and tighten adjustment
knob securely.
Seat Pan
Flat Washer
Adjustment Knob
NOTE: You may now roll or drive your
tractor off the skid. Follow the ap pro pri ate
instruction below to remove the tractor
from the skid.
TO ROLL TRACTOR OFF SKID (See
Op er a tion section for location and
function of con trols)
1. Press lift lever plunger and raise
at tach ment lift lever to its highest po-
si tion.
2. Release parking brake by depressing
clutch/brake ped al.
3. Place gearshift lever in neutral (N)
po si tion.
4. Roll tractor forward off skid.
5. Remove banding holding defl ector
shield up against tractor.
TO DRIVE TRACTOR OFF SKID (See
Op er a tion section for location and
func tion of con trols)
der stand and follow all in struc tions in the
Operation section of this manual. Be sure
tractor is in a well-ventilated area. Be sure
the area in front of tractor is clear of other
people and objects.
1. Be sure all the above assembly steps
2. Check engine oil level and fi ll fuel tank
3. Sit on seat in operating position,
4. Place gear shift lever in neutral (N)
5. Press lift lever plunger and raise
6. Start the engine. After engine has
Seat
7. Depress clutch/brake pedal into full
8. Slowly release clutch/brake pedal and
Shoulder
Bolt
9. Apply brake to stop tractor, set park-
10. Turn ignition key to "STOP" position.
Continue with the instructions that follow.
INSTALL MULCHER PLATE
(If previously removed)
1. Raise and hold defl ector shield in
02464
2. Place front of mulcher plate over front
3. Hook front latch into hole on front of
4. Hook rear latch into hole on back of
shield from mow er.
9
WARNING: Before starting, read, un-
have been com plet ed.
with gasoline.
depress clutch/brake pedal and set the
parking brake.
position.
at tach ment lift lever to its highest posi-
tion.
started, move throttle control to idle
position.
"BRAKE" position and hold. Move
gearshift lever to 1st gear.
slowly drive tractor off skid.
ing brake and place gearshift lever in
neutral position.
up right po si tion.
of mower deck open ing and slide into
place, as shown.
mower deck.
mower deck.
CAUTION: Do not remove defl ector
Defl ector
Shield
Mulcher Plate
Latch
Hooks