Specifications - Sony MHC-EC59 Operating Instructions Manual

 If the system is brought directly
from a cold to a warm location or is
placed in a very damp room, moisture
may condense on the lens inside the
CD player, and cause the system to
malfunction. In this situation, remove
the disc, and leave the system turned
on for about an hour until the moisture
evaporates.
On heat buildup
 Heat buildup on the unit during
operation is normal and is not cause
for alarm.
 Do not touch the cabinet if it has been
used continuously at a high volume
because the cabinet may have become
hot.
 Do not obstruct the ventilation holes.
On the speaker system
This speaker system is not magnetically
shielded, and the picture on nearby TV
sets may become magnetically distorted.
In this situation, turn off the TV, wait
15 to 30 minutes, and turn it back on.
If there is no improvement, move the
speakers far away from the TV.
Cleaning the cabinet
Clean this system with a soft cloth
slightly moistened with a mild detergent
solution. Do not use any type of abrasive
pad, scouring powder, or solvent, such as
thinner, benzine, or alcohol.

GB

Specifications

Main unit
Amplifier section
The following measured at AC 127 V, 60 Hz
(Mexican model)
The following measured at AC 220 V,
50/60 Hz (Argentine model)
The following measured at AC 120 V, 220 V,
240 V, 50/60 Hz (Other models)
Power output (rated):
25 W + 25 W (at 6 Ω, 1 kHz, 1%
THD)
RMS output power (reference):
60 W + 60 W (per channel at 6 Ω,
1 kHz)
Inputs
PC IN (stereo mini jack):
Sensitivity 800 mV, impedance
22 kilohms
Outputs
PHONES (stereo mini jack):
accepts headphones with an
impedance of 8 Ω or more
SPEAKERS: impedance: 6 Ω
USB section
Supported bit rate:
MP3 (MPEG 1 Audio Layer-3):
32 kbps  320 kbps, VBR
WMA: 48 kbps  192 kbps
AAC: 48 kbps  320 kbps
Sampling frequencies:
MP3 (MPEG 1 Audio Layer-3):
32/44.1/48 kHz
WMA: 44.1 kHz
AAC: 44.1 kHz
(USB) port:
Maximum current:
500 mA