Change The User - HP 54 Basic Cutter User Manual

3.
Press
4.
Press
5.
Press
6.
Press
7.
Press
and measure the length of the cut line. The length to be entered is the distance between line 1 and line 2,
as shown below.
NOTE:
is inaccurate, then re-calibrating may reduce the cutter's accuracy. For maximum accuracy, you are
recommended to set the cutter to Metric units of measurement for the calibration.
8.
Use
between the two lines along the length of the vinyl roll.
9.
Press
10.
Use
between the two lines across the width of the vinyl roll.
11.
Press
12.
Press

Change the user

There are four user configurations, all of which have the same parameters. The parameters can be set to
different values for each user, so that you can reconfigure the cutter for a different type of job or substrate
quickly and easily by selecting a different user.
NOTE: Initially, the parameters are set to the same values for all users.
These are the most important cutting parameters that can be saved for different users:
Speed | Pressure | Offset | Tool
●
FlexCut settings
●
Substrate and length calibration values
●
Overcut
●
Paneling
●
ENWW
. System setup appears on the screen.
.
or to scroll through the menu until you reach Calibrations. Press
or to scroll through the menu until you reach Cal. length. Press
again. The cutter reloads the substrate and starts the length calibration. Take out the substrate
The cutter can only be as accurate as the accuracy of the calibration itself. If your measuring device
, , , and
to confirm.
, , , and
to confirm.
twice to leave the menu.
to change the value on the screen to the length that you measured
to change the value on the screen to the length that you measured
.
.
Change the user 21