Puxing PX-578 Manual page 14

2. rotate the Encoder knob until 'VOICE'(menu 119) is displayed
3. push ENTER;
4. turn the Encoder knob to activate or select from CHS, ENG (CHS=Chinese;
ENG=English);
5. press ENTER again;
6. press the VFO/MR to exit.
Select CTCSS and DCS tones
There are 3 kinds
--- RX and TX
--- RX only
--- TX only
1. Press the MENU and ENT button;
2. rotate the Encoder knob to item 12/13/14 until 'C-CDC? 012'(setting RX/TX
tone), 'R-CDC? 013'(setting RX tone), 'T-CDC? 014'(setting TX tone), is
displayed
3. push ENTER;
4. turn the Encoder knob and select the desired CTCSS tone, or press side key 3
to select DCS tone,
(While selecting the codes, if you press side key 4, you will select the
normal (N) or inverted (I) DCS codes.)
5. press ENTER to confirm and VFO/MR to exit ;
Channel name edit
1. press the MENU and ENT button;
2. turn the Encoder knob until 'NAME?'(menu 15) is displayed
1. push ENTER;
2. turn the Encoder knob to select ON/OFF;
3. press ENTER
4. press the VFO/MR to exit
Repeater shift adjustment (for communications through repeaters)
1. Press the MENU and ENT button;
2. rotate the Encoder knob until 'OFFSET'(menu 16) is displayed
3. push ENTER;
4. turn the Encoder knob and select the repeater shift. (VHF range 0-42Mhz,
UHF range 0-80Mhz)
5. press ENTER ;
6. press the VFO/MR to exit
Repeater shift (for communications through repeaters)
To activate this function, follow these steps: