Getting Started; Installing The Battery - Kyocera Jet User Manual

1 GETTING STARTED

Installing the battery

Your Kyocera Jet/Angel phone comes with
a removable lithium ion (LI Ion) battery.
Fully charge the battery before using the
phone.
To install the battery:
1. Hold the phone face
down.
2. Slide the tab at the
bottom of the door
up and remove the
battery door.
3. Place the battery in
the phone casing
with the metal
contacts facing the
right side of the
phone.
4. Replace the battery
door by sliding the notches into the
openings near
the top of the phone.
5. Snap the battery
door closed to
secure the cover into
place.
 
PAGE 1 Installing the battery
Charging the battery
You must have at least a partial charge in
the battery to make or receive calls.
To charge the battery:
1. Connect the AC adapter to the jack on
the bottom of the phone.
2. Plug the adapter into
a wall outlet.
The battery icon in the
upper-right corner of the
screen tells you whether
the phone is:
• Charging (the icon is animated)
• Partially charged
• Fully charged
Recharging the battery
You can safely recharge the battery at any
time, even if it has a partial charge.
Note: To remove the battery, make sure
the phone is powered off.

GETTING STARTED