Cisco Catalyst 2960-X Hardware Installation Manual page 26

Installing the Power Cord Retainer (Optional)
Procedure
Step 1 Choose the sleeve size of the power cord retainer based on the thickness of the cord. The smaller sleeve can
be snapped off and used for thin cords.
Step 2
Slide the retainer around the AC power cord, and pass it around the loop on the switch.
Figure 19: Inserting the Retainer Through the Lanced Loop
1 AC power cord
2 Power cord retainer
Step 3 Slide the retainer through the first latch.
Figure 20: Sliding the Retainer Through the Latch
1 AC power cord
Catalyst 2960-X and 2960-XR Switch Hardware Installation Guide
26
3 Sleeve for thinner power cords
4 Loop
3 Latch
Switch Installation
OL-28309-02