Module Installation And Service; Product Labeling; Module Label; External Label - Redline Communications RDL-3100-RMA Product Manual

RDL-3100 RMA MODULE

2.3 Product Labeling

2.3.1 Module Label

The modular transmitter will display a label referring to the FCC ID registration number
and the IC registration number. An information label is applied directly to the modular
transmitter (example shown below).
Do not to remove any labels from the module.

2.3.2 External Label

Information labels are applied to the final product. The final product features a label on
the outside surface listing the registration number for the enclosed module. Do not to
remove any labels from the module or the final product.
3

Module Installation and Service

3.1 Installation into a Final Product

The module must be installed only by trained professional technicians authorized by
Redline or its agents. The module must be installed only into an approved enclosure
(see Conditions of Use) and only at an approved manufacturing facility or service depot.
Redline shall retain complete control over the final installation of the module and will
ensure compliance of the end product to all applicable FCC/ISED regulations. The
module must be installed only into an approved enclosure (see Conditions of Use) and
only at an approved manufacturing facility or service depot.
Redline licensing of the modular transmitter includes monitoring to ensure compliance in
the operation and use of the module as expressly specified within this manual. This
includes restrictions against modification of the module hardware, approval of the final
70-00184-05-00 Proprietary Redline Communications © 2017
PRODUCT MANUAL
Page 8 of 25 February 17, 2017