Ised Notices; Table 49: Ised: Rdl-3100-Rma Recommended Safe Distances - Redline Communications RDL-3100-RMA Product Manual

RDL-3100-RMJ
(2) This device must accept any interference received, including interference that
may cause undesired operation.
FCC Information to Users @ FCC 15.21:
5.
Warning:
Communications could void the user's authority to operate the equipment.

5.1.2 ISED Notices

Deployment in Canada
This Class B Digital apparatus meets all the requirements of the Canadian Interference-
Causing Equipment.
The following notices about deployment in Canada are included in training and
documentation provided to professional installers and operators of the final product:
The final product must be professionally installed.
1.
WARNING -- ISED RF Exposure Warnings
2.
To satisfy ISED RF exposure requirements for RF transmitting devices, the following
distances should be maintained between the antenna of this device and persons
during device operation:

Table 49: ISED: RDL-3100-RMA Recommended Safe Distances

Frequency (MHz)
To ensure compliance, operation at closer than these distances is not
recommended. The antenna used for this transmitter must not be collocated in
conjunction with any other antenna or transmitter.
The RDL-3100-RMA has been designed to operate with an antenna having a maximum
gain of 32 dBi. Antenna having a higher gain is strictly prohibited per regulations of
ISED. The required antenna impedance is 50 ohms.
This device has been designed to ensure that radio frequency emissions are maintained
within the band of operation under all normal operating conditions listed in this manual.
This device complies with ISED license-exempt RSS standard(s). Operation is subject to
the following two conditions:
This device may not cause interference, and
1.
This device must accept any interference, including interference that may cause
2.
undesired operation of the device.
To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropic radiated power (EIRP) is not more than
that required for successful communication.
Déploiement aux le Canada
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Les avis suivants à propos du déploiement au Canada sont inclus dans la formation et la
documentation fournies aux installateurs professionnels et les opérateurs du produit
final:
Le produit final doit être installé par un professionnel.
1.
AVERTISSEMENT - ISED avertissements d'exposition RF
2.
70-00184-05-00
PRODUCT MANUAL
Changes or modifications
Deployment
4900 PMP/PTP
5800
5800
Proprietary Redline Communications © 2017
not expressly
Separation Distance
220 cm (86.6") or more
PMP 20 cm (7.9") or more
PTP 220 cm (86.6") or more
Page
approved by Redline
23 of 25 February 17, 2017