Table of Contents
Advertisement
Check the following before requesting service:
SYMPTOM GENERAL
No power
Plug the AC cord into an AC outlet.
An ON/OFF switch is located on the unit's rear panel. Please set the commuter to ON position.
Power on, but unit not functioning properly
Unplug the unit and wait about one totwo hours to allow the player to dry.
Press the POWER button, then unplug the power cord. Wait one minute and then plug the unit back in.
Clean disc and insert label side-up.
This is normal; try another function.
No picture
Connect the equipment according to the instructions in this manual.
Select the appropriate video input mode, usually VIDEO or AV.
Connect the video cables securely.
Turn the TV on.
HDMI Mode Display Problem
When you select an HDMI display mode which is not supported by
choose, for example, 1080i while your television supports up to 720p only), you get a black
screen. As a result, you cannot change the HDMI resolution in the setup menu. In this case, plug
the Video Composite cable (included) and press the VIDEO button of the remote control repeat-
edly until the correct video mode is selected and the picture appears on the screen again. Then
you can press the SETUP button in order to choose a lower resolution that is supported by your
television.
iPod Mode Display Problem
Please connect this device to a TV via the composite video output cable (included) or with S-Video
cable. The playback of HDMI is not supported.
No sound
Connect the equipment according tothe instructions in this manual.
Connect as per this manual, and press the AUX Mode button on the remote.
Connect the speaker cables securely.
Turn the external unit on.
SYMPTOM DVD
The unit does not start playback.
Make sure to insert a DVD.
Insert DVD correctly.
Clean the disc.
Some functions do not operate as stated.
This is normal; try another function.
TROUBLESHOOTING GUIDE
37
your television (if you
Advertisement
Table of Contents
