Basic Operation; Setting The Clock; Setting The Timer - Crosley CR1206A Instruction Manual

BASIC OPERATION

Function select
1 Press FUNCTION /
AUX2
2 When the set is on, press POWER /
switch the unit off. LCD backlight will be turned
off and shown message"GOOD BYE" for 2
seconds, then the STANDBY LED is turned on.
Note: In the standby mode, the tone, sound
settings, tuner presets and the volume level (up
to a maximum volume level of 30) will be stored
in the unit's memory.

SETTING THE CLOCK

After connecting the system to power supply, set
the clock first.
1 Press POWER /
mode
- The display shows the time
- "0:00" flashes by default if you have not set the
clock
2 In the Standby mode, press and hold
PROGRAM / over 1 second.
- The hours digit starts flashing.
3 Press the FF / o FB /
the hours.
4 Press PROGRAM /
The minutes digit starts flashing
5 Hold down FF /
the minutes.
6 Press PROGRAM /
The minutes digit stop flashing, the clock begins
to run.
7 Press PROGRAM /
and 24 hours, shown as below
Basic Operation
to select among:
AUX1
to switch the unit to Standby
repeatedly to set
again to confirm.
o FB / repeatedly to set
again to confirm.
to select between 12

SETTING THE TIMER

The unit can be used as an alarm clock, whereby
the selected source (CD, TUNER, USB, SD CARD
OR PHONO) to start playback at a preset time.
Make sure the clock is set before using the timer.
1 In the standby mode, press and hold TIMER
/ on the remote over 1 second, icon " " and
message" TURN ON" start flashing. Press TIMER
to
/ again on the remote to begin the "SYSTEM
POWER ON" timer setting.
2 Press FF /
3 Press TIMER /
setting mode.
4 Press FF /
5 Press TIMER /
"SYSTEM POWER OFF" timer setting. Icon " "
and message "TURN OFF" start flashing. Press
TIMER /
setting.
6 Press FF /
7 Press TIMER /
setting mode.
8 Press FF /
9 Press TIMER /
setting the source from wake up. Default at
TUNER mode. Message TUNER start flashing.
10 Press FUNCTION /
The unit will be waked up from last tuned station
if TUNER mode is selected.
11 Press TIMER /
complete timer on/off setting. Icon " " will keep
display on LCD if timer is set.
Note: The wake up sound level will be increased
gently to preset volume level.
12 Press TIMER /
on/off the timer. The icon " " will be on/off
respectively.
8
or FB / repeatedly to set hours.
on the remote to enter minutes
or FB / repeatedly to set minutes.
on the remote again to begin
on the remote again to begin timer
or FB / repeatedly to set hours.
on the remote to enter minutes
or FB / repeatedly to set minutes.
on the remote again to begin
to select wake up source.
AUX2 AUX1
on the remote again to
on the remote control to turn