Table 18; Step Task - Cisco ASR 9000 Series Configuration Manual

Configuring Serial Interfaces on the Cisco ASR 9000 Series Router

Table 18

following SPAs and line cards.
•
•
•
•
•
•
Table 18 Overview: Configuring a Serial Interface on an E1 DS0 Channel
Step Task
1. Configure the T3 controller
parameters and set the SPA mode to
be E3.
21 E1 controllers are automatically
created.
2. Create and configure DS0 channel
groups on the E1 controllers.
3. Configure the Serial interfaces that
are associated channel groups you
created in Step 2.
Table 19 Overview: Configuring a Serial Interface on a E1 DS0 Channel
Step Task
1. Configure the SONET controller
parameters and STS stream for T3
mode.
2. Configure the T3 controller
parameters and set the mode to E1.
21 E1 controllers are automatically
created.
3. Create and configure DS0 channel
groups on the E1 controllers.
4. Configure the Serial interfaces that
are associated channel groups you
created in Step 2.
OL-26061-03
provides a high-level overview of the tasks required to configure an E1 serial interface on the
2-Port and 4-Port Channelized T3 SPA
4-Port Channelized OC-12/DS3 line cards
1-Port Channelized OC-12/DS0 SPAs and line cards
1-Port Channelized OC-48/DS3 SPAs and line cards
1-Port Channelized OC-3/STM-1 SPA
2-Port Channelized OC-12c/DS0 SPA
Module
"Configuring Clear Channel T3/E3
and Channelized T3 and T1/E1
Controllers on the
Cisco ASR 9000 Series Router"
"Configuring Clear Channel T3/E3
and Channelized T3 and T1/E1
Controllers on the
Cisco ASR 9000 Series Router"
Configuring Serial Interfaces on the
Cisco ASR 9000 Series Router
Module
"Configuring Channelized
SONET/SDH on the
Cisco ASR 9000 Series Router"
"Configuring Clear Channel
T3/E3 and Channelized T3 and
T1/E1 Controllers on the
Cisco ASR 9000 Series Router"
"Configuring Clear Channel
T3/E3 and Channelized T3 and
T1/E1 Controllers on the
Cisco ASR 9000 Series Router"
"Configuring Serial Interfaces on
the
Cisco ASR 9000 Series Router"
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
Information About Configuring Serial Interfaces
Section
Configuring a Channelized T3
Controller
Configuring an E1 Controller
How to Configure Serial Interfaces
Section
Configuring SONET T3 and
VT1.5-Mapped T1 Channels
Configuring a Channelized T3
Controller
Configuring an E1 Controller
How to Configure Serial Interfaces
505