Advertisement
11. Adding New Cards by Master Card
a.
1. Read master card once (1 beep, Right Yellow LED stay on)
2. Enter slot position 001~999 (Left Green LED stay on, Right Yellow
LED rapid flash to indicate the slot position is available
3. Read new card (1 beep), then enter 5-digit PIN 99999 (1 beep, Right
Yellow LED stay on)
4. Press # (1 beep , Right Green LED stay on) back to standby mode
b.
1. Read master card once (1 beep, Right Yellow LED stay on)
2. Enter slot position 001~999 (Left Red LED stay on, Right Yellow LED
rapid flash to indicate the slot position is unavailable)
3. Press＊＊(1 beep, Left Green LED stay on, Right Yellow LED rapid
flash)
4. Repeat the steps of 11-a to add new card.
12. Turning Anti-Tamper Alarm Function ON/OFF
1. Enter programming mode
2. Press＊6 (Right Yellow LED rapid flash)
3. Press 01 (1 beep, Right Yellow LED stay on) – function OFF
Press 02 (1 beep, Right Yellow LED stay on) – function ON
4. Press # (1 beep , Right Green LED stay on) back to standby mode
13. Turning Doorbell Alarm Function ON/OFF
1. Enter programming mode
2. Press＊2 (Right Yellow LED rapid flash)
3. Press 01 (1 beep, Right Yellow LED stay on) – function OFF
Press 02 (1 beep, Right Yellow LED stay on) – function ON
4. Press # (1 beep , Right Green LED stay on) back to standby mode
14. Reseting the Master Code to Default Value
Turn off the power → Press # continuously, and energized (1 beep) the
master code is reset to default value.
Copyright © Gianni Industries, Inc. All rights reserved.
P-MU-DG-800 Ver. B Published: 2010.11.22
Page: - 8 -/ 8
Advertisement
