Advertisement
a.
1. Enter programming mode
2. Press ＊4 to select slot position 00~09 (Left Green LED stay on, Right
Yellow LED rapid flash to indicate the slot position is available)
3. Read new card (1 beep, Right Yellow LED stay on)
4. Press # (1 beep , Right Green LED stay on) back to standby mode
b.
1. Enter programming mode
2. Press＊4 to select slot position 00~09 (Left Red LED stay on, Right
Yellow LED rapid flash to indicate the slot position is unavailable)
3. Press＊＊(1 beep, Left Green LED stay on, Right Yellow LED rapid
flash)
4. Repeat the steps of 8-a to add new card.
9. Changing Master Code
1. Enter programming mode
2. Press＊3 (Right Yellow LED rapid flash)
3. Enter 5-digit master code twice e.g. 45678 45678 (1 beep, Right Yellow
LED stay on)
4. Press # (1 beep , Right Green LED stay on) back to standby mode
10. Adding a New Master Card to Relay 1
a.
1. Enter programming mode
2. Press＊7 (Left Green LED rapid flash, Right Yellow LED rapid flash to
indicate the slot position is available)
3. Read new card to set as Master Card (1 beep, Right Yellow LED stay
on)
4. Press # (1 beep , Right Green LED stay on) back to standby mode
b.
1. Enter programming mode
2. Press＊7 (Left Green LED stay on, Right Yellow LED rapid flash to
indicate the Master Card had been stored)
3. Press＊＊(1 beep, Left Green LED rapid flash, Right Yellow LED rapid
flash)
4. Repeat the steps of 10-a to add new master card.
Copyright © Gianni Industries, Inc. All rights reserved.
P-MU-DG-800 Ver. B Published: 2010.11.22
Page: - 7 -/ 8
Advertisement
