Resetting Your Device; Using The Wps (Optional); Internet Access; Configuring Your Pc - Zte Z291DL User Manual

ZTE Z291DL User Manual

Resetting Your Device

There are two ways to reset your device.
Reset your device on Web UI.

Please refer to the section
Reset your device by pressing and holding the Reset key.

1. Remove the back cover.
2. Find a hole with a mark RESET on one side of the device bottom surface.
3. Press and hold the Reset key hidden in the hole with a pin for 3 seconds or longer.
4. Factory reset will take effect and then the device will restart.

Using the WPS (Optional)

If your client device supports WPS, you don't have to input the password manually after WPS
has been available. Please do the following steps:
1. Log into the Web UI by visiting http://192.168.0.1 or http://mobile.hotspot.
Select Settings > Wi-Fi Settings > Basic Settings to enable the Broadcast Network
2.
Name (SSID) and to set the Security Mode.
3. Set a Wi-Fi password in OPEN-WEP mode, WPA2 (AES)-PSK mode or
WPA-PSK/WPA2-PSK mode and then click Apply to confirm the settings.
4.
Press and hold the WPS key to start Wi-Fi Protected Setup authentication process.
5.
Enable the WPS function on your client to respond this authentication process.
6.
Follow the system prompts on your client to finish the connection.
NOTE:
For the detailed operations about the client, please refer to the client's instruction.

Internet Access

Configuring Your PC

The following procedure describes how to configure the Internet Protocol in the Windows 7 operating
system for Wi-Fi connection.
Settings - Device Settings – Reset
Confidential and Proprietary Information of ZTE CORPORATION 5
in this user manual.