Toggling Between Calls; Join Calls; Call Termination; Redial - Uconnect 4C/4C NAV User Manual

dialpad, recent calls, SMS Inbox or from the phonebooks.
To go back to the first call, refer to "Toggling Between
Calls" in this section. To combine two calls, refer to "Join
Calls" in this section.

Toggling Between Calls

If two calls are in progress (one active and one on hold),
press the "Swap" button on the Phone main screen. Only
one call can be placed on hold at a time.
You can also push the Phone
the active and held phone call.

Join Calls

When two calls are in progress (one active and one on
hold), press the "Join Calls" button on the Phone main
screen to combine all calls into a Conference Call.

Call Termination

To end a call in progress, momentarily press the Phone
"End" button on the touchscreen or the Phone "End"
button on the steering wheel. Only the active call(s) will
be terminated and if there is a call on hold, it will
become the new active call.
button to toggle between

Redial

Press the "Redial" button on the touchscreen, or push the
"VR" button and after the "Listening" prompt and the
following beep, say "Redial."
The Uconnect Phone will call the last number that was
dialed from your mobile phone.

Call Continuation

Call continuation is the progression of a phone call on the
Uconnect Phone after the vehicle ignition has been
switched to OFF.
NOTE: The call will remain within the vehicle audio
system until the phone becomes out of range for the
Bluetooth connection. It is recommended to press the
"transfer" button on the touchscreen when leaving the
vehicle.

ADVANCED PHONE CONNECTIVITY

Transfer Call To And From Mobile Phone

The Uconnect Phone allows ongoing calls to be transferred
from your mobile phone to the Uconnect Phone without
terminating the call. To transfer an ongoing call from your
PHONE MODE 67
5