Install/Remove The Battery; Minisd Memory Card - Pidion BM-150R Series Manual

II. Understanding
Your Phone

4. Install/Remove the Battery

[Install the Battery]
1. Put the battery in line with
the left part of the PDA
and then push the right part to
lock.
2. Put the projected part of the
cover on top of the groove in
the back and then push
carefully with both thumbs.
[Remove the Battery]
1. Push down using both thumbs
to remove the cover.
2. Raise the battery by using the
groove on the lower part to remove
the battery.
We strongly recommend that you use the adapter which was purchased with the product for charging the battery. However, the 24 pin charger of an ordinary
mobile phone may also be used to charge the PDA battery. (Due to the characteristics of a standard charger, there may be small discharge of electricity
despite the charger being fully charged.)

5. MiniSD Memory Card

Make sure that the gold plate terminal of the memory card is pointed
towards the back when inserting into the MiniSD slot. For removal
push the exposed part of the memory card. It will pop out.
• Important data should always be
• Frequent insertion/removal of
saved on the computer. The company
the memory card, or applying
will not take any responsibility for the
too much force to it, may cause
the product to malfunction. loss of data on this product.
• If the memory card cannot be
• Card removal and turning the
power off/on using the memory removed easily, instead of removing it
card may result in loss of data with force, inquire to the service center
or cause the memory card and
for its removal, or ask for an exchange
PDA to malfunction.
or refund of the product.
11