Hitachi HT-4139-28 Maintenance Manual page 124

REV0 10.02.15
9.7 Adjusting the Ribbon Holder
Take the following steps to construct the Ribbon Holder.
-H9-8-
Tools Needed: Magnetic Philips Screwdriver (No.2)
#108 DC Motor
Bind-head screw x2
#106 Gear(NMB)
Ribbon Holder
Bind-head screw x2
①
Loosen 2 bind-head screws on the Ribbon Holder
and remove the Ribbon Holder
Ribbon Holder
②
Loosen 2 bind-head screws on the DC Motor and
attach the DC Motor by applying pressure in the
direction of the arrow.
#108 DC Motor