Ametek SI1500 User And Installation Manual page 6

3.0 Installation into a Panel (cont)
CAUTION: Do not over tighten the screws as this may damage the case of the instrument.
WARNING: On installing or removing the SI1000, you must be aware of any hazardous equipment or materials in the vicinity. Make sure that
any equipment into which the SI1000 system is to be installed is switched off and made safe.
CAUTION: Avoid installing the SI1000 close to switch gear, contactors or motor starters.
CAUTION: Do not place other signal and power supply wiring in the same loom as the SI1000 wiring.
CAUTION: Use screened cables for all leads, with the screen earthed at one end only.
3.0 Installation into a Panel (cont)
5
502893 issue 4.1