Cleaning The Oven Door; Oven Ceiling - Zanussi ZOB35805XK User Manual

1. Put 300 ml of water into the Aqua cleaning
container at the bottom of the oven.
2. Set the function
3. Set the temperature to 90 °C.
4. Let the appliance operate for 30 minutes.
5. Deactivate the appliance and let it cool
down.
6. When the appliance is cool, clean the
inside of the oven with a soft cloth.
WARNING!
Make sure that the appliance is
cool before you touch it. There is
a risk of burns.

Oven ceiling

WARNING!
Deactivate the appliance before you
remove the heating element. Make
sure that the appliance is cold.
There is a risk of burns.
Remove the shelf supports.
You can remove the heating element to clean
the oven ceiling more easily.
1. Remove the screw which holds the heating
element. For the first time, use a
screwdriver.
2. Carefully pull the heating element down.
3. Clean the oven ceiling with a soft cloth with
warm water and a cleaning agent, and let it
dry.
Install the heating element in the opposite
sequence.
18
.
Install the shelf supports.
WARNING!
Make sure that the heating element
is correctly installed and that it does
not fall down.

Cleaning the oven door

The oven door has two glass panels. You can
remove the internal glass panel to clean it.
CAUTION!
Do not use the appliance without the
internal glass panel.
The direction in which you open the
door depends on your oven model.
You open the door from the right
side in some models and from the
left side in others.
A
Press the buttons at
1
the sides of the door
trim (A) on the upper
cover and pull it
upwards to remove it.
Clean the door with a wet sponge and rub it dry
with a soft cloth. Do not use steel wool, acids or
abrasive cleaning agents because they can
damage the surface.
When the oven door is clean, install the glass
panel in the opposite sequence. The screen-
printing zone must face the inner side of the
door. Make sure that after the installation the
surface of the glass panel frame on the screen-
printing zones is not rough when you touch it.
Make sure that you put the glass panel in the
rubber distance holders.
B
Hold the inner glass
2
B tightly with both
hands and slide it
upwards to remove it
from its initial
position. Make sure
that you tightly hold
glass B to prevent
the glass from falling.
www.zanussi.com