Table of Contents
Advertisement
Available languages
Available languages
SAFETY and GENERAL INFORMATION
Save these instructions. For your safety, read, understand, and follow the information provided with and on this jack
before using. The owner and operator of this equipment shall have an understanding of this jack and safe operating
procedures before attempting to use. The owner and operator shall be aware that use and repair of this product
may require special skills and knowledge. Instructions and safety information shall be conveyed in the operator's
native language before use of this jack is authorized. If any doubt exists as to the safe and proper use of this jack,
remove from service immediately.
Inspect before each use. Do not use if broken, bent, cracked or damaged parts are noted. Any jack that appears
damaged in any way, or operates abnormally shall be removed from service immediately. If the jack has been or
suspected to have been subjected to a shock load (a load dropped suddenly, unexpectedly upon it), immediately
discontinue use until jack has been checked by a factory authorized service center (contact distributor or manufacturer
for list of authorized service centers). It is recommended that an annual inspection be done by qualified personnel.
Labels and Operator's Manuals are available from manufacturer.
PRODUCT DESCRIPTION
Clutch Handler is designed for clutch/ flywheel removal and installation. Intended use: to remove, install and transport
(in lowest position) both 14" and 15-1/2" clutches and flywheels. The two most common spline sizes, 1-3/4" and 2"
diameter, are included with this product. The head plate enables clutch to be positioned in either horizontal position
for clearing underneath vehicle or vertical position for installation and removal. The spline sleeve rotates 360 degrees,
turns side to side and vertically tilts for precise clutch alignment. Model 40501 is designed to be used in conjunction
with Omega Clutch handler, 40500 only. Refer to Figure 4 to ensure all parts are included before use.
!
WARNING: NEVER use for any purpose other than those uses outlined above!
SPECIFICATIONS
Model
Capacity
40500
500 lb.
Pump Handle
Release Valve Knob
Rear Caster
Jack Size
(L x W )
Height
44-1/2" x 22-1/2"
16-1/2"
Pilot Shaft
Spline Sleeve
Head Plate
Release Pin
Lifting Arm
Figure 1 - Model 40500 Components
Min.
Max.
Height
42"
2
Spline
Pilot
Dia.
Shaft Dia.
1-3/4" & 2"
1"
Horizontal Position
Tilt Adjustment Bolt
Front Caster
Advertisement
Table of Contents
