Advertisement
INSTALLATION
The MUDHSB-B can be used with any 12-volt battery and can be mounted to a variety of bars
using the included hardware. The unit has four wires in its wiring pigtail. The red wire, hot, should
be directly connected to the vehicles positive battery terminal. The black wire, ground, should be
connected directly to the vehicle's chassis where paint has been removed or the negative terminal
on the battery. The orange wire, ignition, should be connected to the ignition wire on the vehicle. The
blue wire, optional output, can be used to turn on additional amplifiers.
The unit features fully adjustable clamps for mounting to bars between
⁄
" and 1
⁄
". The clamps
7
1
8
4
can be used to mount to many styles of handlebar and roll bar systems. The included brackets are
versatile, so mounting to angled bars is possible.
Scenario 1 - User first mounts clamps to handlebar, then installs sound bar.
• Choose the correct size strap clamp for the handlebars.
• Assemble mid-section to bottom bracket using included 4mm Allen Screw and 10mm Hex Nut.
• Ensure that the spacing between the brackets is between 3" and 6.75".
• Slide the sound bar into the brackets from the left side, so the brackets can clear the buttons
without damaging them.
• Rotate the sound bar so the speakers are directed at the rider's head.
• Tighten the 5mm Allen Screws to lock the sound bar in place.
• Tighten the 2mm Set Screws.
• Connect wires to power, ground, and ignition.
4
M T X . C O M
MTX005245 MUDHSB Owners Manual.indd 4
7/9/15 2:10 PM
Advertisement
