Related Manuals for MTX Thunder Sports MUDSYS31
Summary of Contents for MTX Thunder Sports MUDSYS31
- Page 1 OWNER’S MANUAL MUDSYS31 / MUDSYS41 / MUDSYS46 BLUETOOTH OVERHEAD AUDIO SYSTEMS M T X . C O M...
-
Page 2: Important Notice
• Rubber Inserts 100mm x 120mm (2) INTRODUCTION Thank you for purchasing this MTX Audio Bluetooth Overhead Audio System that is designed to deliver exceptional quality music to your off road vehicle. This easy to install and use all in one unit is capable of withstanding the wind, sun, rain, and more ensuring that you can enjoy it wherever life takes you. They are designed to fit a variety of ORV make and models that use factory roll cages. -
Page 3: Wiring Diagram
MODELS MUDSYS31 Fits Roll Cages 32.25" to 38.75" Wide (Inside Roll Bar Measurement) Physical Dimensions - 8.5" (216mm)H x 4.125" (105mm)D x 29.92" (760mm)W MUDSYS41 Fits Roll Cages 43.0" to 49.0" Wide (Inside Roll Bar Measurement) Physical Dimensions - 8.5" (216mm)H x 4.125" (105mm)D x 40.5" (1029mm)W MUDSYS46 Fits Roll Cages 49.25"... - Page 4 SOURCE UNIT BUTTON LAYOUT 1. Power / Mute Button - Press the button to turn power On. When the power is On, press the button to mute the audio output. Press and hold the button to turn power Off. 2. + Button - Press the button to increase the volume. 3.
-
Page 5: Settings Menu
• Press MODE for 2 seconds, BT PAIR will be displayed. • Quickly release and then hold MODE for 2 more seconds and “Pairing” will be displayed. • Select “MTX SOUNDBAR” from the list of available Bluetooth devices. • The device will then pair to the unit. -
Page 6: Clock Operation
CLOCK OPERATION Press and hold the “Band” button for 2 seconds to display the clock. When displayed, press and hold the “Band” button for 2 seconds until the hour number is flashing, then use the +/- buttons to adjust the hour. Once set to desired number, press the “Band” button again and the minutes number will flash. Use the same process to set the minutes to desired number. INSTALLATION The MUDSYS31, MUDSYS41, and MUDSYS46 will mount to a variety of roll cages that have a diameter between 1.75"... - Page 7 Remove the bolts from the C-bracket so the top bracket and C-bracket can be properly positioned around the roll cage. Once the C-brackets are in the proper location for mounting, the bolts should be retightened to a torque specification of 65-70 inch/lbs. The unit has an integrated wiring harness that includes a power, ground, and accessory wire that are designed to connect to the vehicle’s battery providing it power.
-
Page 8: Troubleshooting
© 2018 Mitek Corporation. All rights reserved. MTX, Mud Nation, and Let’s Do Something Dirty are trademarks of Mitek Corporation. All other trademarks are property of their respective owners. Designed and Engineered in the U.S.A.