1. Manuals
  2. Brands
  3. Williams-Sonoma Manuals
  4. Indoor Furnishing
  5. Wythe Burl Wood Bar
  6. Assembly instructions

Williams-Sonoma Wythe Burl Wood Bar Assembly Instructions

Hide thumbs
1
2
3
4
5

Advertisement

Table of Contents

ASSEMBLY INSTRUCTION FOR WYTHE BURLED WOOD BAR

IMPORTANT SAFETY INSTRUCTIONS:

 Please read all instructions carefully before assembling.
 For your safety, assembly by two or more adults is strongly recommended.
 Keep instructions for future use.
 Use only vendor supplied hardware to assemble. Using unauthorized hardware could jeopardize the stuctural
integrity of the product.

PARTS INCLUDED:

(A) Cabinet
(B) Shelf

HARDWARE ENCLOSED:

(C) Shelf Pin
ASSEMBLY INSTRUCTIONS:
To replace the wine rack to be shelf (B), please follow the instruction below:
1.
Release the door of the Cabinet (A) with pressing the locking pin at the back of hinges as shown (Fig.1),
and pull the door as shown (Fig.2)
Fig.1
1 pc
1 pcs
4 pcs
A
(D) Anti-Tip Kit
1set
Door
Locking Pin
Hinges
Page 1 of 5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Wythe Burl Wood Bar and is the answer not in the manual?

Questions and answers

Related Manuals for Williams-Sonoma Wythe Burl Wood Bar

Summary of Contents for Williams-Sonoma Wythe Burl Wood Bar

  • Page 1 ASSEMBLY INSTRUCTION FOR WYTHE BURLED WOOD BAR IMPORTANT SAFETY INSTRUCTIONS:  Please read all instructions carefully before assembling.  For your safety, assembly by two or more adults is strongly recommended.  Keep instructions for future use.  Use only vendor supplied hardware to assemble. Using unauthorized hardware could jeopardize the stuctural integrity of the product.
  • Page 2 Fig.2 Hinges Door Pull the Wine Rack out from the case as shown (Fig.3) Fig.3 Install Shelf Pins (C) into the middle level nut on the Cabinet by turning clockwise as shown (Fig.4) and then put the Shelf (B) inside Cabinet as shown (Fig.4). To adjust the upper and lower shelf level, insert the shelf pins (C) into upper or lower level holes then move the shelf (B).
  • Page 3 Fig.4 Insert the hinges into the mounting plate and ensure that the locking pin is locked properly as shown (Fig.5). Hinges Door Fig.5 Locking Mounting Plate Page 3 of 5...
  • Page 4 Assemble is complete. If the floor is uneven, adjust the recessed levelers found on the bottom of the furniture. Turn the Leveler counter clockwise to increase the height Turn the Leveler clockwise to decrease the height  Carefully grasp one side of the furniture and elevate it slightly to provide access to levelers. ...
  • Page 5 FURNITURE TIPPING RESTRAINT WARNING: This product is only a deterrent. It is not a substitute for proper adult supervision. Manufacturer assumes no liability for improper installation or excessive loads placed on screws, brackets or straps. Young children may be injured by tipping furniture and the use of a tipping restraint is highly recommended. When properly installed, this restraint will provide protection against tipping of furniture.

Table of Contents