Whyte Inter-Grip Seat Clamp - Whyte 29 CS Supplementary Service Manual

Quick Release Lever Type: Fig.2
Tools: 4mm allen key.
(Note, refer to the seat-pin manufacturers instructions in conjunction with these notes).
To Adjust the seat height with the QR Lever assembly fitted, simply undo the QR Lever (3)
from the Closed position to the Open position. Next adjust the height of the Seat Pin to the
desired level, and close the QR lever (3) from the Open position to the Closed position. The
QR closing force can be adjusted and optimised by turning the QR M5 Adjuster Bolt (6)
clockwise or anti-clockwise with the use of a 4mm allen key before closing the QR Lever
(3).
CAUTION! When adjusting the saddle height you MUST obey the Minimum insertion
depth requirement marked on the Seat Post.
3.3: WHYTE INTER-GRIP SEAT CLAMP ADJUSTMENT
The Inter Grip seat clamp design is present on several models of Whyte bikes. It allows ad-
justment of the saddle height & direction.
Ite
Description
m
1 Cap-screw, M6 x 30 long
Inter-Grip Sleeve, thread-
2
ed.
"O" Ring seal, fits in
3
sleeve groove.
Inter-Grip Sleeve, no
4
thread.
Inter-Grip Pad for
5
Ø30.9mm seat-post
6 Main Frame
Fig.3: Inter-Grip Seat Clamp
Tools Required:
CAUTION! Avoid over-tightening the seat clamp.
In particular, "dropper" seat-posts such as SRAM Reverb may not work correctly if the seat
clamp is over tightened.
Figure 3. To adjust the seat height and/or direction, using the 5mm Allen key, undo the M6
2018 Edition 1
WHYTE Service Manual
5mm AF Allen Keys (2 off, 1 fitted to a 3Nm to 15Nm Torque Wrench)
Fig.3: Inter-Grip Seat Clamp
Page 11