Entering Characters - LG -TM510 Operator's Manual

the memory address, you will be unable to see the phone number or to correct it.

Entering Characters

You will be provided with 5types of modes (English Lower, English Upper, Digil, Special Char,
Icon) to enter the characters. Use the upside (é) key to change among the modes while entering
the characters. The present mode is indicated on the lower center of the screen. Whenever you
press the upside (é) key, the modes will change in the order of "ENG" - "eng" - "DIG" - "SPC"
- "ENG" `````` . Select the mode before you enter the characters, and enter the characters.
1. When the mode is ready for entry, the cursor ("_") will be indicated
on the space for entry.
(If you enter one character, the cursor will move to the following
space automatically and wait for entry.)
2. Use the right side (è) key or the "0" key in the "ENG" - "eng" state to place a space among
the characters.
3. Verify if the cursor is placed where the character is to be entered, and change the mode by
using the upside/downside (t / s) key.
4. Verify if the mode requested is indicated on the lower center of the screen, and enter the
character.
5. Use 8 keys of [2]~[9] to enter the character in the "eng" and
"ENG" mode. One key is designated with three or more than three
characters. Therefore, press each key repeatedly for a short period
of time until the character requested appears. For example, if you
want to enter a character "K", set the "ENG" mode with the
upside/downside (s / t) keys and then press [5] key twice for short time continuously.
6. Enter the numbers of 0~9 with ten keys from [0] to [9] in a "DIG" mode.
(Reference: The "ENG", "eng" and "DIG" modes remain in the same state even after you
enter a character, while the "SPC" mode automatically change into an "ENG" mode after
you enter one character.)
8 M510 Ver. 1.1.5