Advertisement
AUDIO QUALITY
When using the AUX IN JACK input, audio quality will be regulated directly from the device.
FREQUENCY SELECTION
On default modulation frequency is fixed on 87.7 Mhz.
IPLUGRDS TX has an internal selector which allows you to set up to 4 different frequencies.
Use dip-switches 1 and 2 to choose a new frequency
Depending on dip-switches different combinations you can set a different frequency as
described in TAB 1.
TAB 1
DIP 1
DIP 2
FREQUENCY
OFF
OFF
87,7 MhZ
ON
OFF
87,9 MhZ
OFF
ON
88,1 MhZ
ON
ON
88,3 MhZ
SPECIAL SETTING
It is possible to set your IPLUGRDS TX either according the audio characteristics of compression
or the pre-emphasis.
Some files could have a high dynamic of audio level amplitude, which may cause clipping
especially at very low or very high frequencies, with the result of a low audio quality.
In order to avoid this, IPLUGRDS TX includes an audio compressor able to level the audio
dynamic. This compressor, if necessary, can be excluded by positioning pin 4 ON (see below).
OFF
ON
6
5
4
3
2
1
TAB 2
ALTERNATIVE FREQUENCY (AF)
88.5 MhZ
88.7 MhZ
88.9 MhZ
87,7 MhZ
ON
OFF
6
5
4
3
2
1
Pag 4
AUX IN WORKING MODE:
IPLUGRDS TX allows you to connect the audio input trough the JACK 3.5mm supplied with the
harness.
The AUX IN profile selection must be done with the REMOTE.
Anyway each time you disconnect your IPOD, IPLUGRDS automatically select the AUX IN
profile.
If you want to confirm this selection, you have just to press the SRC remote button within 10 sec.
otherwise IPLUGRDS TX will switch off.
Input audio levels are compatible with any audio source.
If the volume is too low or too high, please adjust it through the connected audio source volume.
The available functions on your remote are:
AUX IN FUNCTION MODE
SHORT SINGLE PRESSURE
KEY
<< ROOT
KEY
>> RDM
KEY
II > SRC
ROOT
Pag 13
LONG PRESSURE
—
—
—
—
—
SELECTION
SOURCES/OFF
<<
>>
RDM
SRC
Advertisement
