Download Print this page
Powerfinn Robust 1100/24 Installation And User Manual

Powerfinn Robust 1100/24 Installation And User Manual

Robust series

Advertisement

Robust series Battery Chargers
Installation and User Manual
30.May.2017
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the Robust 1100/24 and is the answer not in the manual?

Questions and answers

Summary of Contents for Powerfinn Robust 1100/24

  • Page 1 Robust series Battery Chargers Installation and User Manual 30.May.2017...
  • Page 2: Table Of Contents

    FCC/IC-information for optional radio module ............12 General Powerfinn Robust series chargers use modern switching technology. The intelligent microcontroller extends the battery life by supervising the charging process. The charger is compact, silent and meets the EU safety and EMC requirements.
  • Page 3: Safety Instructions

    Safety Instructions In addition to the safety measures mentioned in chapter ‘Operations’, the following personal precautions should be taken whenever charging batteries. 1. For emergency situations ensure in advance that help is available in time of need. 2. Batteries contain acid that is harmful to the eyes, skin and clothes. Always wear overalls and safety goggles.
  • Page 4: Installation

    Installation The charger should be installed indoors in a low humid area. These instructions apply to all types of chargers produced at the time of writing; types prefixed with "R" and "NSR". The following points must be respected when installing the charger. 1.
  • Page 5 Charger slides to mounting plate from above and can be secured using screws. For fan cooled models, mounting plate is of different size but of similar type:...
  • Page 6: Charging Configuration

    Charging configuration The charger voltage, charging algorithm and configured battery capacity should correspond to the battery parameters. Attempting to charge a battery with wrong charging configuration may result in considerable damage. For example, too large configured battery capacity results in excessive charging current. Do not attempt to charge non-rechargeable batteries.
  • Page 7: Operation

    Operation Read these operating instructions carefully before using the charger for the first time. Also read the chapter "Safety instructions" thoroughly. It must be ensured that children do not play with the device. To charge a battery with ”Robust" series charger, follow these instructions: The factory default setting is - Algorithm LK10-06 freely ventilated lead-acid - Battery capacity 50 Ah...
  • Page 8: Indicators

    Indicators Mains is connected. Radio module is ON. Charger can be assembled with optional radio module. Module allows access to configuration and history log of the charger. Indicator definitions: No light Continuous light Flashing...
  • Page 9 Indications: Only blue mains indicator is lit. Charger is waiting for a battery to be connected. Green flashing: STOP pressed, charging paused Yellow continuously lit: main charging phase Defined in charging algorithm. Also power supply mode, power on. Additional charging. Defined in charging algorithm Equalize charging.
  • Page 10 Alarm, low charger temperature or sensor fault Alarm, BMU init fail Alarm, regulation fault Alarm, battery error Alarm, CAN timeout Alarm, CAN slave timeout...
  • Page 11: Troubleshooting And Repair

    Troubleshooting and repair If the cause of malfunction cannot be found, contact your retailer or the manufacturer. If fuse is defective, charger has to be sent for control/repair. Only authorized persons can repair the charger. Determining operation mode Charger has several operation modes; for example charger, SDO power supply and several remote controlled power supply modes.
  • Page 12: Fcc/Ic-Information For Optional Radio Module

    FCC/IC-information for optional radio module This product contains FCC ID: B7WACCESS, IC: 10687A-ACCESS. ------------------------------------------WARNING!------------------------------------------------------- Changes/modifications not approved by the responsible party could void the user’s authority to operate the equipment. This transmitter must not be relocated or operated in conjunction with any other antenna or transmitter. This equipment complies with FCC and IC radiation exposure limits set forth for an uncontrolled environment.