Using The Bathing Cushion - Mangar HBA0120 User Instructions

Installation and Use

Using the Bathing Cushion

WARNING: ALWAYS INFLATE THE BATHING CUSHION AND USE THE BATHING CUSHION TO LOWER
YOURSELF INTO THE BATH. This allows the micro processor in the Airflo to calculate the required
battery power to raise the Bathing Cushion and if it calculates that there would be insufficient
power, it will not allow the hand control to operate the down function.
to get into the bath
• With the Bathing Cushion in the bath,
ensure that all 4 suction cups are adhering
to the floor of the bath, fill the bath with
water at a suitable temperature (Maximum
50°C/120°F).
• With the Bathing Cushion fully inflated, sit
on the seat and then swing your legs into
the bath.
• To maintain stability, ENSURE THAT YOU
ARE SEATED CENTRALLY AND RIGHT AT
THE BACK OF THE SEAT SO THAT YOU ARE
TOUCHING THE BACKREST (fig. 6).
WARNING: Do not sit further forwards
as shown in figure 7, as you may slide off
the front of the seat and sustain possible
serious injury.
• Select 'Down' to lower yourself into the
bath. KEEP YOUR KNEES BENT AND FEET
FLAT ON THE FLOOR OF THE BATH AS YOU
ARE LOWERED SO AS TO AVOID SLIDING
FORWARDS ON THE SEAT. Hold the sides
of the bath or grab handles for added
support if required.
• You can stop at any time by releasing the
'Down' button.
Note: you may find it more comfortable to
leave a small amount of air in the Bathing
Cushion, to cushion yourself on the bottom
of the bath (fig. 8).
8
6
7
8