Installation And Use; Before Fitting The Bathing Cushion In The Bath; Fitting The Bathing Cushion In The Bath - Mangar HBA0120 User Instructions

Installation and Use

Before fitting the Bathing Cushion in the
bath
• Remove any non slip mats from the area
where the suction cups will be positioned.
• Ensure the bottom of the bath is clean
and smooth, with no oil or bath cleaner
residues that will prevent the suction feet
from sticking. WARNING: The suction cups
may not adhere to the surface in baths
that have been re-enamelled or that have
rippled or textured surfaces. Do not use if
the suction cups do not adhere to the bath.
• Pass the air hose through the loop in the
corner of the backrest (A fig.1), on the
side that you propose getting into and out
of the bath. The air inlet valve (B) can be
rotated, allowing the hose to be led to the
appropriate corner.

Fitting the Bathing Cushion in the bath

• Fold the backrest over onto the seat as
indicated in fig. 2. Lightly place the deflated
Bathing Cushion in the middle of the empty
bath with the 'handle' (C) aligned with the
centre of the bath.
• Hold the 'handle' and pull the Bathing
Cushion towards the slope of the bath
until there is a gap of approximately 25mm
between the bath slope and 'handle'
(C figs. 2 & 3).
• Firmly press all four suction cups down
and check that they are securely stuck to
the bath. Wet them to help them stick if
necessary.
• Fold the backrest out so that it rests on the
slope of the bath.
6
1
C
2
25mm approx.
C
3
A
B