Table of Contents
Advertisement
Connection
shows how to connect the Base Station to a terminal, PC or
Figure 2
other host device. Turn off the host before connection and consult the
manual for that equipment (if necessary) before proceeding.
Base Station Connection and Routing —
1
Cable
and Interface (I/F) Cable connectors into their respective ports in
the underside of the Base Station (see
either loop the cables around the routing clips and back through the
routing channel to the front of the Base Station as shown, or the cables
can be fed directly out the back of the Base Station via the routing clips.
Figure 2
. Connecting the Base Station
Power Cable
Routing
Clips
Bottom of Base Station
Host Connection —
scanner was ordered, however you should verify before connection that
the scanner's cable type is compatible with your host equipment. Most
connections plug directly into the host device as shown in
board Wedge interface cables have a 'Y' connection where its female end
mates with the male end of the cable from the keyboard and the remain-
ing end at the keyboard port on the terminal/PC.
1. The AC Adapter (Power Cable) is an optional device used only if the host/terminal cannot
by itself supply adequate power to drive the Base Station (via the interface cable).
4
I/F
Cable
Routing
Channel
I/F Cable
Base
Station
The interface type was specified at the time your
Fully insert the Power
). Alternatively, you can
Figure 2
Power Cable
PowerScan® 7000BT SRI
Optional
AC Adapter
. Key-
Figure 3
Advertisement
Table of Contents
