Installing The Micro-Sim Card - Zte Z6200 Quick Start Manual

Getting to Know Your OBD2 Device
Indicator lights
Indicator Status
Green
LED 1(Power) blinking
Green
solid
Red
solid
Green
LED 2(Signal)
solid
Green
blinking
NOTE:
The charging temperature should be lower than 60 .
.
Description
Powered by the internal
battery.
Powered by the vehicle
battery.
Turn on but not register.
Registered to the 4G
network.
Connected to the 4G LTE
network and data is being
transferred.
3

Installing the micro-SIM card

1. Use the tray eject tool to take out the card tray.
2. Put the micro-SIM card into the card tray and slip it into the
card slot.
WARNING!
To avoid damage to the phone, please do not use other kinds of
SIM cards, and do not use a non-standard micro-SIM card cut
from a SIM card. You can get the standard micro-SIM card from
your service provider.
3. Close the micro-SIM card cover.
Installing Your OBD2 Device
1. Make sure your vehicle is parked outside in a safe location
and the engine is turned off.
2. Find your Vehicle's On-Board Diagnostics (OBD II) connector
port.
NOTES:
The OBD II port is usually located under the driver's dash
side of your car, often within 18 inches of the steering
wheel (as 1 to 8 shown in the following picture).
4