Advertisement
Quick Links
Advertisement
Related Manuals for AUDAC ANI22
Summary of Contents for AUDAC ANI22
- Page 1 ANIxx Installation Manual www.audac.eu...
-
Page 2: Packaging Contents
WaveDynamics™ Dante audio network interface The ANIxx are Dante audio network interfaces for use with WaveDynamics™ supporting amplifiers, supporting two (ANI22) or four (ANI44) networked audio channels. The installation of this optional interfaces allows these amplifiers to be integrated into any DANTE enabled AV network and flawlessly transfer digital audio with any compatible product on the market, ranging from music sources to microphone systems, mixers, and many more. -
Page 3: Mounting And Connecting
Instructions Mounting and connecting Step 1: ATTENTION Make sure the amplifier is powered off and the power inlet is disconnected from the mains power before the enclosure is opened. Step 2: Open the amplifiers’ enclosure by carefully removing the screws from the top panel of the device, and lifting it. - Page 4 Step 3: 3.1. Remove the latch from the Ethercon compatible connector on the connection board by putting a flat screwdriver underneath the clip and pulling back screwdriver and latch together. This will simplify the assembly of the ethernet connection board in the back of the unit.
- Page 5 REMARK Detaching the upper input board (containing terminal block and RS-232 sockets) may facilitate the installation. Make sure it is well fastened again afterwards. Step 4: Once the Ethernet connection PCB is correctly installed, the supplied ethernet connection cable shall be plugged to the RJ45 connection socket in the inner side of the ethernet connection board.
- Page 6 Step 5: Mount the ANIxx main interface board into the amplifier: 5.1. Remove the screw on the most left side of the front display board of the amplifier and replace it by the supplied M3 spacer. 5.2. Insert both supplied nylon snap-in spaces into the appropriate holes in the ANIxx main interface board as indicated in the below image.
- Page 7 5.3. Fix the ANIxx main interface board into the amplifier by simply clicking it onto the front display board using both snap-in spacers. Make sure the female pin-header on the main interface board is well positioned and matching the male counterpart on the front display board of the amplifier.
- Page 8 Step 7: Double check whether all internal wires are well connected and well positioned. After all connections are successfully made, the top cover of the amplifier can be re-fitted and fixed uing the original screws. Step 8: To guarantee the correct functioning of the amplifier with the installed ANIxx Dante network audio interface, verify whether the current running software version fully supports this interfaces functions.
-
Page 9: Additional Information
Ethercon compatible RJ45 connector Network specification Standard 100 Mbit or 1 Gbit network Mounting Integration in amplifier chassis Power consumption 1.5 Watt Weight 0.090 Kg Compatible devices (implementation) ANI22 SMA Series WaveDynamics™ amplifiers ANI44 SMQ Series WaveDynamics™ amplifiers Protocol (DANTE) compatible devices https://www.audinate.com/products/dante-enabled... - Page 10 Notes...
- Page 11 Notes...
- Page 12 Notes...
Need help?
Do you have a question about the ANI22 and is the answer not in the manual?
Questions and answers