No.
Port
Power port
9
SDI port
10
VISCA IN port
11
VISCA OUT
port
12
HDMI OUT
13
port
HD-VI port
14
Network port
15
Installation
The VPC800 can be mounted on top of a display (such as TV set and monitor), wall-mounted,
ceiling-mounted, or placed horizontally, which you can select based on the site requirements.
If the display is thicker than 170 mm or the display is wall-mounted, the VPC800 can be
installed in any possible way other than be mounted on top of the display.
If the display is 170 mm or thinner, the VPC800 can be mounted on top of a display or placed
horizontally.
Placed Horizontally
Description
adapter and is not used with TX or TEX0 series
videoconferencing endpoints.
Functions as a 12 V DC power input port.
Functions as a bayonet-neill-concelman (BNC) connector to
output 3G-SDI and HD-SDI signals.
3G = 3rd Generation
HD = high definition
SDI = serial digital interface
Functions as a serial port to connect to an HD videoconferencing
endpoint or cascades to an upper-level camera. In addition, this
port can be used to upgrade the camera.
Cascades a lower-level camera. This port complies with the
Video System Control Architecture (VISCA) standard.
VISCA is a trademark of Sony Corporation.
Outputs HDMI2.0 signals and supports a resolution of up to
4K2Kp 60 fps.
Inputs serial control signals, infrared signals, and 12 V power.
Outputs digital visual interface (DVI) or YPbPr video signals.
Performs operations such as camera upgrade as well as camera
angle adjustment (upward, downward, left, or right) and image
scaling (zoom in or out) through Telnet.
Place the camera on a flat surface.
If you have to place the camera on a sloping surface,
ensure that the slope is less than ±15° or the camera may
not function properly.
3