Deflation; Deflation Option; Led Night Light; Usb Power Socket - Intex 620PC Owner's Manual

DEFLATION

1. Attach the AC line cord to the pump cord connector and plug into an AC electrical
outlet. See Fig (2 & 3).
2. Press the deflation button (
3. When the airbed is almost deflated, begin rolling the airbed from the foot of the airbed
towards the head of the airbed where the pump is located. See Fig (8).
Press " " to switch OFF when the airbed is completely deflated. See Fig (9).
Note: The pump will automatically switch OFF after about five and half minutes of
operation when the pump is left unattended. If there is still some air inside, repeat step
#2 thru #3 as necessary.
4. Disconnect the AC line cord from the pump and the electrical outlet, place it inside the
cord compartment and close the cover.

DEFLATION OPTION

1. If electrical power is not available then open line cord compartment cover, unscrew
the exhaust valve cap to release the air. See Fig (10). Begin rolling the airbed from the
foot of the airbed towards the head of the airbed where the pump is located to remove
all the air. Close the exhaust valve cap back.

LED NIGHT LIGHT

1. Press the button once to light up the pump control panel interface.
2. Press the button twice to turn on the LED night light as well.
3. Press 3 times to turn OFF all the lights.

USB POWER SOCKET

Output: 5 V DC / 2.0 A
Suitable for smartphones, tablets and portable audio devices charging.
SAVE THESE INSTRUCTIONS
(311IO) 620PC BUILT-IN ELECTRIC PUMP ENGLISH 4.875" X 7.25" 07/08/2016
) to deflate. See Fig (7).
FIG (7)
FIG (8)
FIG (10)
Page 4
311
IO
FIG (9)