Table of Contents
Advertisement
SWING MODE
S
SWING ON: Press FUNCTION under the unit's ON state
to activate the SWING function and
ENTER/CANCEL to confirm.
NOTES:
The SLEEP, TURBO or BLOW mode is the same as the SWING mode.
After the setting is made, the user must press ENTER/CANCEL to revert to the setting status or the unit stops operating automatically
five seconds later.
SLEEP MODE
S
SLEEP ON: Press FUNCTION under the unit's ON
state until the unit enters the SLEEP mode. Press
ENTER/CANCEL to confirm.
S
SLEEP OFF: When the SLEEP function is activated,
press FUNCTION to enter the SLEEP mode. Next, press
ENTER\CANCEL to exit the function.
S
blinks. Next, press
Fig. 13 - Swing mode
In the COOLING or DRY modes, the temperature increases by
1.8_F (1_C) after the unit runs under the SLEEP mode for 1 hour
and 1.8_F (1_C) after another hour. Afterwards, the unit will
continue to run at this temperature.
In the HEATING mode, the temperature decreases by 1.8_F (1_C)
after the unit runs under SLEEP 1 for one hour and 1.8_F (1_C) after
another hour. Afterwards, the unit runs at this temperature (see Fig.
14).
Fig. 14 - Sleep mode
6
SWING OFF: When the SWING function is on, press
FUNCTION to enter the SWING setting interface
press ENTER/CANCEL to cancel the function (see Fig. 13).
. Next,
Advertisement
Table of Contents
