TROUBLESHOOTING
Problem
No power
No sound
Sound distortion
FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the followingmeasures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Possible Cause
AC/DC adaptor plug not connected to the
wall outlet
Volume in minimum position.
The connected device is not in play mode.
Input source incorrect.
Volume level too high
Solution
Plug to the wall outlet.
Turn MAIN VOLUME knob to increase the
volume.
Play the music in the connected device and
make sure the volume level is in high level.
Press the MODE button to set the input
source to the desired function.
Turn MAIN VOLUME knob to decrease the
volume.
8