Sanyo DC D30 Instruction Manual page 6

Inserting batteries
APJSLfM-3/R6
X
2
(not supplied)
2
Note:
Always remove batteries ifthe remote control is notto be used fora month
or more. Batteries left in the unit may leak and cause damage.
Remote control range
iii
Remote sensor
Operation
By using the remote control, you can operate the system in the same way
as with the controls on the main unit.
ADJUSTING THE CLOCK
The clock display blinks when the mains lead is connected to the AC
5. Press the MEMORY switch. The clock starts.
outlet for the first time.
Example: To set "7:30PM",
1. Press the CLOCK switch for 1 or more seconds.
~
~1 - whenatimesignalisheard.
The time can be set accurately by pressing the MEMORY switch
1
The "CLOCK' and hours displays blink.
These operations can be done, even if the power is off.
2. Press the V or A TUNING switch to set the "hours."
The clock operation and memory are backed up even with a power
~-
failure lasting 30 seconds or less.
When a power failure lasts for more than 30 seconds, the memory
contents will be retained for a few days, but the clock display will blink.
3. Press the MEMORY switch.
Reset the time when the display blinks because of a power failure.
m
Reset the timer ON/OFF times as well.
The minutes display blinks.
4. Press the V or A TUNING switch to set the "minutes."
m
-5-