Service Adjustments - Sanyo CE32WH3-F Service Manual

SERVICE ADJUSTMENTS

Note: Some items of the service adjustments for this chassis are controlled by the CPU, IC801, and the
adjustments are carried out by using the RC handset.
[After replacing the Memory IC (IC803)]
The memory IC, IC803, stores the service adjustments data for each circuit, therefore, when the memory IC is
replaced, it should be programmed with "OPTION SETTING" on previous page and the following adjustments, refer
to futher adjustment on page 14.
ADJUSTABLE SERVICE ADJUSTMENT
REGULAR
Item No. OSD
1 VC1
2 VC2
3 AGC
4 SCR
5 GRY
6 CUT
7 CTR
8 OSD
WIDE
Item No. OSD
4 P V-WA
6 P V-L
8 P H-P
9 P H-W
11 P PCC
16 P TRP
IMPOTANT NOTICE
Do not attempt to adjust service adjustments not listed on the above otherwise it may cause
loss of performance and product safety.
To enter to the Service Mode
+ Press and hold the "RECALL" button on the remote control and then press the "SERVICE switch"inside of the
door. The adjustment window will appear on the screen.
F7YLV
Description
B/G VCO Adjustment
France-L/L' VCO Adjustment
AGC Adjustment
Screen Adjustment
White Balance Adjustment
Cut-Off Drive Adjustment
Contrast Adjustment
OSD Positioning Adjustment
Description
Vertical Size Adjustment
Vertical Centre Adjustment
Horizontal Centre Adjustment
Horizontal Size Adjustment
Pcc Adjustment
Trapezoid Distortion Adjustment
ADJUST
REGULAR
WIDE
OTHERS
TDA9320
TDA9330
TDA9178
TDA4977
SELECT:
EXIT : RECALL
OK
-12-