Option Setting - Sanyo CE32WH3-F Service Manual

OPTION SETTING

[After replacing the Memory IC (IC803)]
The memory IC, IC803, stores the option data of TV set and service adjustments data for each circuit, therefore,
when the memory IC is replaced, it should be programmed with the following setting and "SERVICE ADJUSTMENT"
on next page.
To enter to the Option Mode
+ Press and hold the "RECALL"button on the remote control and "PROG.+" button on the front panel of the TV. The
option window will appear on the screen.
To set the option mode
+ Highlight the desired option item by using the UP or DOWNbutton .
+ To switch the option mode, use the Volume - (LEFT) or Volume + (RIGHT) button.
+ The data which is set in the option mode is stored into the memory IC automatically.
Following table shows the available option items and default setting mode.
Option Mode
ON-TIMER
SORT MODE
PLUG & PLAY
WELCOME TEXT
CODE TEST
WSS
Exit from the Service Mode
+ Press the RECALL button.
OPTION
ON-TIMER
SORT MODE
PLUG & PLAY
WELCOME TEXT
CODE TEST
WSS
ADJUST :
Mode
ON or OFF
ATS EURO PLUS
or AUTO TUNE
or AUTO TUNE/SORT
ON or OFF
ON or OFF
OFF or ON
ON or OFF
ON
ATS EURO PLUS
ON
ON
OFF
ON
EXIT : RECALL
Note
Default "ON"
Depends upon destination
Default "ON"
Display message when first set up, default "ON"
For factory use, default "OFF"
Wide Screen Signaling available, default "ON"
-11-
F7YLV