Installation Guide; Unboxing; Installation Requirements - Silhouette RESERVE Use & Care Manual

INSTALLATION

Unboxing

Warning! Excessive weight hazard!
Use two persons to move and install this appliance
to prevent injury.
Unpacking Instructions:
• Cut the bottom strap.
• Detach the box from the front, back and sides.
• Using two or more persons, slide the box up and
off the appliance.
• Remove the plastic bag.
• Using two or more persons, lift the appliance off
of the foam base.
• Recycle all packing materials.
5 Consumer Support
1.5 in (3.8 cm) diameter
35 in
*If electrical outlet in
(88.9 cm)
adjacent cabinetry
Electrical Access Electrical Access
25 in
(63.5 cm)
24 in (61 cm)
1-844-455-6097

Installation Requirements

Selecting the proper location will ensure excellent
performance levels for your appliance. Choose a
location where the appliance will not be exposed
to direct sunlight or heat emitting sources such as a
heater or stove.
It is not recommended to install this appliance into a
corner or directly beside a wall. This is to allow the
appliance to have a greater than 90° door opening.
This appliance is front breathing. Do not block the
front air vent as this will result in high operating
temperatures, poor system performance and higher
energy usage.
This appliance is designed for indoor use only.
The listed depth requirement in the below image is
assuming that the electrical outlet is located in the
adjacent cabinetry or is fl ush mounted on the rear
wall.
2 in (5 cm)
6 in
(15.2 cm)
90°