Table of Contents
Advertisement
micro CA-25
Inspection Camera
WARNING!
Read this Operator's Man ual
carefully before using this
tool. Failure to understand
and follow the contents of this
manual may result in electri-
cal shock, fire and/or serious
person al injury.
uality Products Online at:
micro CA-25
GlobalTestSupply
www.
Operator's Manual
.com
sales@GlobalTestSupp
Advertisement
Table of Contents
Related Manuals for RIDGID micro CA-25
Summary of Contents for RIDGID micro CA-25
- Page 1 CA-25 Operator’s Manual micro CA-25 Inspection Camera WARNING! Read this Operator’s Man ual carefully before using this tool. Failure to understand and follow the contents of this manual may result in electri- cal shock, fire and/or serious person al injury.
-
Page 2: Table Of Contents
General Safety Information Work Area Safety....................2 Electrical Safety ....................2 Personal Safety....................2 Equipment Use and Care ..................2 Service.......................3 Specific Safety Information micro CA-25 Inspection Camera Safety............3 Description, Specifications and Standard Equipment Description......................4 Specifications.....................4 Standard Equipment ..................4 Controls ......................4 FCC Statement .....................5 Electromagnetic Compatibility (EMC) ..............5... - Page 3 CA-25 micro CA-25 Inspection Camera micro CA-25 Inspection Camera Record Serial Number below and retain product serial number which is located on nameplate. Serial GlobalTestSupply www. .com uality Products Online at: sales@GlobalTestSupp...
-
Page 4: Safety Symbols
CA-25 Inspection Camera Safety Symbols In this operator’s manual and on the product, safety symbols and signal words are used to communicate important safety information. This section is provided to improve understand- ing of these signal words and symbols . -
Page 5: Service
CA-25 Inspection Camera • Do not use equipment if the switch Read these precautions carefully before using the micro CA-25 In spec tion Cam - does not turn it ON and OFF. Any tool era to reduce the risk of electrical shock that cannot be controlled with the switch is or other serious injury. -
Page 6: Description, Specifications And Standard Equipment Description
The micro CA-25 Inspection Camera comes – Contact your local RIDGID distributor. with the following items: – Visit www.RIDGID.com or • micro CA-25 with Fixed 4' (1.2 m) 17mm www.RIDGID.eu to find your local Imager RIDGID contact point. • 3' (90 cm) RCA Cable –... -
Page 7: Fcc Statement
To connect, hold the imager head as shown in Changing/Installing Batteries Figure 5 . Slip the semicircle end of the acces - he micro CA-25 is supplied without batteries sory over the flats of the imager head as installed. If the power status light is red, the shown in Figure 5 . -
Page 8: Pre-Operation Inspection
Set up the micro CA-25 In spec tion Cam - era and work area according to these 5. Inspect the camera head lens for con- procedures to reduce the risk of injury densation. -
Page 9: Operating Instructions
CA-25 Inspection Camera • Clear, level, stable, dry place for opera- 3. Make sure the micro CA-25 Inspec tion tor. Do not use the inspection camera Camera has been properly inspect ed. while standing in water. 4. Install the correct accessories for the ap- 2. -
Page 10: Viewing
RCA cable. Open the rubber cover on RIDGID tools are warranted to be free of de- the side of the screen and insert the RCA fects in workmanship and material. Should cable into the TV-OUT jack. -
Page 11: Battery Disposal
CA-25 Inspection Camera For EC Countries: Do not dispose of elec trical equipment with house- hold waste! According to the European Guide - line 2002/ 96/EC for Waste Elec trical and Electronic Equipment and its imple men tation into national legislation, elec-...