Page 1
Ultra High Speed Burnisher Model L1500-20 Patent pending INDUSTRIES, INC., 1351 W. Stanford Ave., Englewood, CO 80110 USA 303/762-1800 FAX 303/762-0817...
IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions must always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS MACHINE This machine is for commercial use. WARNING: To reduce the risk of fire, electric shock, or injury: Use only as described in this manual.
INSPECTION CONTROLS To install polishing p a d Carefully unpack and inspect your ma- 1 . With the handle locked in the upright position, tilt the machine back until chine for shipping damage. Each unit is the handle is resting on the floor ex- operated and thoroughly inspected before posing the drive pad.
Page 4
DRIVE PAD Two safety interlock thumb levers are 4. Adjust belt tension by inserting screw located on top of switch housing handle. driver between frame and pulley and 1. Remove (3) screws holding pad holder applying downward pressure. Retighten Slide thumb levers outward and apply plate.
Page 5
1 . To access motor remove screws holding motor cover. 2 . Remove rear transport wheels and axle. Remove (2) screws holding motor shroud. (Located front and rear) 4. Remove inspection band from motor. 5. Use a hook to pull brush springs out of the way.
Page 6
FRAME, MOTOR. DRIVER 70088 70329 Scr. 114-20 x 314 PHTF 64A 51041 Light, Neon lndlcalor (115V) 87016 Washer, 87008 Washer, 114 ID x 1 25 OD 70336 Scr. 10-32 x 1 THMS 646 51044 87093 Washer, # l o x 1 0 70330 27316 Handle End Cap...
Page 8
This warranty is in lieu of ail warranties, expressed or implied, and releases Windsor from all other obligations and Iiabllitles. It is applicable only in the U.S.A. and Canada. Windsor Industries is not responsible for costs of repairs performed by persons other than those specifically authorized by Wlndsor.