Table of Contents
Advertisement
Home Display Screen
The home display is used to indicate the status of the router and confirm the main settings quickly.
This is the standard display shown after powering on the router.
The top row indicates the IP address 2.168.17.75 of the router. The "
indicated that Artnet data is being received by the router.
Below it shows the router name Ether2DMX8 and the two internal Artnet nodes. Here the "x" indicates
that no Artnet traffic is received.
Navigate to the next page with the arrow down key.
On the top row the current factory (FP) or user (UPr) preset is indicated, otherwise it reads "No
Preset Active"
The CUE row indicates if a cue is currently running.
The next two pages down show the current DMX port configuration. The first page shows DMX ports 1
through 4.
DMX 1 is set to Node A (A) and Output ( ). The current DMX Universe on this port is 001.
DMX 2 is set to Output ( ) and to clone the DMX traffic from port 1 (CL1).
DMX 3 is set to Node A Input ( ). The current DMX Universe captured is 007.
DMX 4 is disabled (OFF)
Ether2DMX8 User Manual
9
" check mark at the end
© 2010 Martin Professional A/S
Advertisement
Table of Contents
