Configuring Layer 2 Parameters (Gui) - Cisco Catalyst 3650 Series Configuration Manual

Configuring Layer 2 Parameters (GUI)

Configuring Layer 2 Parameters (GUI)

Before You Begin
• You must have administrator privileges.
Step 1 Click Configuration > WLAN > .
The WLANs page appears.
Step 2
Click the WLANs profile of the WLAN you want to configure.
The WLANs > Edit > page appears.
Step 3 Click the Security > Layer 2 > tab.
Parameter
Layer2 Security
MAC Filtering
Fast Transition
Over the DS
Reassociation Timeout
To configure the WPA + WPA2 parameters, provide the following details:
Parameter
WPA Policy
WPA Encryption
WPA2 Policy.
WLAN Configuration Guide, Cisco IOS XE Release 3E (Catalyst 3650 Switches)
66
Description
Layer 2 security for the selected WLAN. Values are the following:
• None—No Layer 2 security selected.
• WPA+WPA2—Wi-Fi Protected Access.
• 802.1X—WEP 802.1X data encryption type. For information on these settings, see the
Layer 2 802.1X Parameters topic.
• Static WEP—Static WEP encryption parameters.
• Static WEP + 802.1x—Both Static WEP and 802.1X parameters.
MAC address filtering. You can locally configure clients by their MAC addresses in the MAC
Filters > New page . You can add a maximum of 12000 local net users. Otherwise, configure
the clients on a RADIUS server.
MAC Filtering is also known as MAC Authentication By Pass (MAB).
Note
Check box to enable or disable a fast transition between access points.
Check box to enable or disable a fast transition over a distributed system.
Time in seconds after which a fast transition reassociation times out.
Description
Check box to enable or disable WPA policy.
WPA2 encryption type: TKIP or AES. Available only if the WPA policy is enabled.
Check box to enable or disable WPA2 policy.
Configuring WLAN Security
OL-32353-01