Porter-Cable C2002 Instruction Manual page 15

TO REPLACE REGULATOR
1. Release all air pressure from air
tank. See "To Drain Tank" in the
Maintenance section.
2. Unplug unit.
3. Remove the console cover.
Console Cover
4. Using an adjustable wrench or
specified wrench remove the
gauges (7/16" wrench), quick
connect (13/16" wrench), and
safety valve (9/16" wrench) from
the regulator manifold.
Safety
Regulator Manifold
Valve
5. Remove the hose by removing
the hose clamp. NOTE: The hose
clamp is not reusable. You must
purchase a new hose clamp,
see the Parts List Manual or pur-
chase a standard hose clamp at
a local hardware store.
Gauges
Quick
Connect
Hose
Clamp
6. Remove pump mounting screws
securing pump (one on each
side).
Pump Mounting Screw
7. Carefully slide pump from brack-
ets and out of the way.
8. Using an adjustable wrench or
5/8" wrench remove the regulator
manifold.
9. Apply pipe sealant to new regu-
lator manifold and assemble,
tighten with wrench.
10. Reapply pipe sealant to gauges,
quick connect, and safety valve.
11. Reassemble all components in
reverse order of removal. Make
sure to orient gauges to read
correctly and use wrenches to
tighten all components.
15 - ENG
Pump
shown
moved
out of the
way
Regulator
Manifold
A15414