Table of Contents
Advertisement
UNPACKING
This filter system was inspected before leaving the factory. The carrier assumes full responsibility for
the safe delivery upon acceptance of the shipment. Check for possible shipping damage immediately
after receipt.
If the filter system is found to be damaged, complete the following steps:
1. Carrier must be notified within 5 business days of receipt.
2. Carrier's local terminal must be notified immediately upon discovery (note time, date, and who
was spoken to), and follow up and confirm with written or electronic communication.
3. All original packing materials must be kept for inspection purposes.
4. The filter system cannot have been moved, installed, or modified.
5. Notify Vulcan Customer Service immediately at 800-814-2028.
TEST THE WATER
Before installing your filter system test the water with a test strip provide with the filter system. If the
water TOTAL HARDNESS test is 17.5 grains (300 PPM) or below continue with installation. If the TOTAL
HARDNESS tests results are higher than 17.5 grains (300 PPM), call your dealer or technical support
immediately. The technical support contact information can be found in the MAINTENANCE Section.
INSTALLATION INSTRUCTIONS
Read all instructions and labels for filter system
before beginning. Position the filter upright on a
horizontal surface without obstructions. Locate
a position that is close to the equipment it will be
supplying water to, where it is out of the way of
possible damage from day-to-day operations,
and where it is accessible for cartridge change
out when needed. There should be a 6" minimum
bottom clearance.
MOUNTING
Measure back plate(Fig.1, Item 1) of filter system
and mark hole mounting locations on wall.
Ensure marks are level, and then drill holes for
anchors (if needed). Anchors must be properly
matched, to allow for wet weight of filter system
and water lines. Secure water filter system to
wall at all four mounting locations.
INSTALLATION
— 6 —
Fig. 1
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the SCALEBLOCKER SMF600 and is the answer not in the manual?