Dishwasher Use - Smart Operation - Whirlpool WDT995SAFM User Instructions

NOTE: You must have successfully completed the "Connectivity Setup" section for the following features to function. Verify that the
Wireless Status icon (A) and either the Amber House icon (C) or Blue House icon (D) are illuminated. Check the Whirlpool
additional dishwasher features, including Remote Enable (B).
Download a Specialty Cycle or My Cycle
The Download & Go™ feature lets you select a Specialty Cycle
or you can design a My Cycle on the Whirlpool
to your dishwasher. When the dishwasher receives the cycle, the
Download & Go LED lights up for several minutes to indicate the
cycle has been received. When you want to use this cycle touch
DOWNLOAD & GO to select the cycle, just as you would do for
any other cycle. Press START/RESUME and close the door within
4 seconds to start the cycle.
HELPFUL TIP: The cycle will be remembered for future use until
a different cycle is downloaded to the dishwasher.
NOTE: If the Download & Go button is touched without a cycle
ready for selection, the LED will blink and you will hear an "invalid
key press" sound (if key activation sounds are turned on). When a
remote start command is received from the app, the dishwasher
will start the cycle. The Remote Enable icon (B) will remain lit.
Smart Delay
(Opt-in through Whirlpool ®
and when supported by your
local utility)
During times of peak electrical rates (if you have opted in) you
may see the Smart Delay icon. When this occurs your dishwasher
will delay according to your opt-in choices to help alleviate peak
power demands on the local utility. The dishwasher will start up
automatically when the peak power demand has decreased. You
may override the smart delay through the app.
10
Dishwasher Use – Smart Operation
® app and send it
app
q
Set a Remote Enable
Remote Enable mode allows you to start your dishwasher
remotely from the Whirlpool
After preparing your dishwasher and selecting your cycle settings,
touch and hold the DOWNLOAD & GO button for 3 seconds. The
Remote Enable icon (B) will be solidly lit.
When a remote start command is received from the app, the
dishwasher will start the cycle. The Remote Enable icon will
remain lit.
HELPFUL TIP: Make sure that your dishwasher door remains
closed and the cycle is not changed until you start the cycle.
Opening the door after a Remote Enable has been set will cancel
the Remote Enable. If the dishwasher needs to be paused to add
dishes, the Remote Enable will need to be reinitiated.
NOTE: If no Wi-Fi connection is available, the Remote Enable
will not be set and Wireless icon (A) will blink for 2 seconds, then
go out.
® app for
A
B
® app.
C
D