Dishwasher Features - Whirlpool WDT995SAFM User Instructions

CONTROLS AND CYCLE STATUS
Press to start or resume a wash cycle.
If the door is opened during a cycle or the power is interrupted, the Start/Resume button LED flashes. Cycle
will not resume until door is closed and Start/Resume is pressed.
NOTE: Push door firmly closed within 4 seconds of pressing Start/Resume or the dishwasher will not start.
If door is not closed within 4 seconds the Start/Resume button LED will flash and an audible tone will sound
when the door is closed.
Press to cancel wash cycle.
Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let dishwasher drain completely.
The display allows you to follow the progress of the dishwasher cycle.
The numeric display counts down while the cycle is running. The exterior status light glows white while the
dishwasher is running and green when the cycle is complete. The Complete light goes out after the door is
opened and then closed.
If you select Sani Rinse option, when cycle is finished, the "Sanitized" indicator glows. If your dishwasher
did not properly sanitize your dishes, the light flashes at the end of the cycle. This can happen if the cycle is
interrupted or water could not be heated to required temperature. The light goes off when you open and close
door or press CANCEL.
The indicator light on the front of the door panel will glow green when a cycle is running and turns off when
the cycle is complete.
TargetClean™ Wash Area
The TargetClean™ wash area is
located at the back of the lower
level rack.
NOTE: You must select the
TargetClean™ wash option to
use this feature. Make sure
items do not interfere with the
water feed tube, spray arms, or
TargetClean™ spray jets.
Load pans, casserole dishes, etc., in the back of the lower
■
dish rack with the soiled surfaces facing the TargetClean™
spray jets.
Only one row of items may face the TargetClean™ spray
■
jets. Stacking, overlapping, or nesting items will keep the
TargetClean™ spray jets from contacting all of the surfaces.
ANYWARE™ PLUS Silverware Basket
The ANYWARE™ PLUS silverware basket can be hung on the
door, the bottom rack, or placed inside the bottom rack.
Door position Rack position

Dishwasher Features

Back of
dishwasher
Rack position side
To open the ANYWARE™ PLUS silverware basket
To unlock, grasp the front panel, pull up, and rotate 90° as shown.
Make sure the front panel is up all the way before rotating. To
unlock and rotate the front panel, grasp the front panel as shown
and pull it up and out.
NOTE: Be sure the front panel of the silverware basket is
completely locked into place before pulling out the bottom
rack and before closing the dishwasher door.
To remove the basket from the door:
1. Grasp the silverware basket by the handle. Slide it toward
the top of the door.
2. Lift the basket off the holding buttons.
To replace the basket in the door:
1. Set the silverware basket on the holding buttons.
2. Slide the basket toward the bottom of the door until it
locks into place.
13